The material flow and microstructural evolution in the friction stir welds of a 6061-Al alloy to itself and of a 6061-Al alloy to 2024-Al alloy plates of 12.7 mm in thickness were studied under different welding conditions. The results showed that plastic deformation, flow, and mechanical mixing of the material exhibit distinct asymmetry characteristics at both sides of the same and dissimilar ...

The failure response of aluminum alloys (Al-6061 and Al-7075) under the condition of simultaneously pre-stressing and laser heating was investigated. Specimens were subjected to predetermined preloading states and then irradiated by continuous wave fiber (Yb) laser. For all specimens, it was found that the yield stress decreased with increasing laser power density. This implies that the load-be...

in magnetic abrasive finishing (maf), abrasive grains as a tool move on surface and can removechip from surface of work piece. in this study al 6061 tube was considered as the work piece andthe effect of finishing parameters such as gap distance between tube and poles, rotational speed oftube, abrasive ration and finishing time on surface roughness was investigated. the mixture offerromagnetic ...

A three-dimensional numerical model is used to simulate the Friction Stir Welding (FSW) process using the computational fluid dynamics package ‘FLUENT’. Two mechanical models: the Couette and the Visco-Plastic fluid flow models for Al-6061-T6 were simulated. The simulation results are compared to experimental data for Al 6061-T6 welded at high rotational (1500–5000 rpm) and travel speeds rangin...

The electrochemical and corrosion behaviour of Al-6061, Al-4.5%Cu and Al-7.5%Cu alloys were studied in 0.50 M KSCN solution at 25 C. Open-circuit potential, Tafel polarization and ICP-AES measurements were used to study the uniform corrosion process on the surfaces of the tested alloys. Cyclic polarization measurements were employed for pitting corrosion studies. Obtained results were compared ...

The experimental investigation of hybrid metal matrix composites with fly ash and graphite reinforced aluminium alloy (Al 6061) composites samples, processed by stir casting route are reported. The aluminium alloy was reinforced with 3 wt.%, 6 wt.%, 9 wt.% fly ash and fixed 3 wt.% of graphite to mixture the hybrid composite. Hardness of the hybrid composite were tested it was found that when th...